Route-Avator Clamping Device
Wynmatic, Inc. Route-Avator is a smaller version of our Cope-Avator.
Designed to clamp a work piece while cope cutting across the end to produce rails for
door construction, it is also very useful for shaping the ends of other small work pieces.
This device does nto need a miter slot to run in as it guides (runs) on the existing fence
using its polycarbonate "see thru" guide. For use on smaller shapers.
Patent Pending. See below for special offer.
Model 35 Route-Avator ---------------------------
$325.00 (plus shipping and
handling)
closeout price: $109.00
|
Features
|
Benefit
|
|
Separate clamp for backer board
|
Quick advance or removal for clean-up cut
|
|
Polycarbonate fence guide
|
No Need for a miter slot in shaper table
|
|
High quality clamps
|
No cumbersome compressed air lines needed
|
|
Base is 1/2 inch thick
|
Flat Mic-6 tm aluminum for accurate cuts
|
|
Cushioned grips
|
Encourages safe placement of hands
|
|
Enhanced capacity
|
Handles material to 5” wide and 1”+ thick
|
|
Aggressive work piece surface
|
Keeps work piece from moving while cutting
|
|
